Abstract
The primary scope of this study lays on system technique solutions of collecting data required for the identification of an aircraft’s nonlinear dynamic model. It is assumed that the aircraft has no inbuilt navigational system, nor any sensors mounted on its control surfaces. The control column and pedals manipulated by the pilot can only visually be observed. For the time of data logging, an external sensory system (GPS, IMU) and a camera system were deployed on the airplane supporting the collection of flight data. The paper presents the data acquisition solutions required for aircraft’s nonlinear model identification, with an emphasis on the determination of the control surface positions as the system’s input signals using image processing. During flight, the control column and pedal positions manipulated by the pilot are recorded using a video camera and with post processing, data is converted to control surface (rudder, elevator, aileron) positions. The 3D positions of the pilot’s control column are determined from 2D pixel values. The input signals are then calculated using this information and the control surface characteristics. The input signals and state variables determined with a state estimator are regarded as input signals for the identification of an aircraft’s nonlinear model.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.