Abstract

Low frequency electromechanical oscillations can pose a threat to the stability of power systems if not properly addressed. This paper proposes a novel methodology to damp these inter-area oscillations using loads, the demand side of the system. In the proposed methodology, loads are assigned to an aggregated cluster whose demand is modulated for oscillation damping. The load cluster control action is obtained from an optimal output feedback control (OOFC) strategy. The paper presents an extension to the regular OOFC formulation by imposing a constraint on the sum of the rows in the optimal gain matrix. This constraint is useful when the feedback signals are generator speeds. In this case, the sum of the rows of the optimal gain matrix is the droop gain of each load actuator. Time-domain simulations of a large-scale power system are used to demonstrate the efficacy of the proposed control algorithm. Two different cases are considered: a power imbalance and a line fault. The simulation results show that the proposed controllers successfully damp inter-area oscillations under different operating conditions and with different clustering for the events considered. In addition, the simulations illustrate the benefit of the proposed extension to the OOFC that enable load to provide a combination of droop control and small signal stability augmentation.

Highlights

  • S PARSELY interconnected power systems typically experience oscillations or power swings between disperse geographical areas

  • This paper develops a methodology to use loads, or the demand side of the system, to damp inter-area oscillations in power systems

  • The paper proposes an extension to the optimal output feedback control (OOFC) approach to ensure that the rows of the optimal gain add up to a scalar value

Read more

Summary

INTRODUCTION

S PARSELY interconnected power systems typically experience oscillations or power swings between disperse geographical areas. A controller for inter-area oscillation damping has been implemented by modulating the power transfer of the Pacific DC Intertie, the longest HVDC line in the United States [21], [23]. This controller uses wide-area measurements from phasor measurement units (PMUs) installed within the western North American Power System (wNAPS). The aggregator-level load modulation signal used in [24], [25] is identical to that in [21] which is determined by a proportional control based on the feedback of frequency difference (note that the work in [21] uses an HVDC link as the actuator).

SYSTEM CLUSTERING AND IDENTIFICATION
System Identification
OPTIMAL OUTPUT FEEDBACK CONTROL DESIGN
TEST POWER SYSTEM AND CONTROL DESIGN
RESULTS
61. The second event is the loss of the line connecting Buses
EFFECT OF SYSTEM OPERATING POINT
EFFECT OF LOAD CLUSTERING AND GENERATOR AGGREGATION
VIII. MODULATION OF DETAILED END-USE LOAD MODELS
CONCLUSION AND FUTURE WORK

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.