Abstract
This paper presents a method for damage detection of bridge cables using the vibration signal coming from the sensor installed in the climbing robot. In this paper, the damage types are crack and local reduction in diameter. The climbing robot consisting of a body and three wheels connected to the body by three springs. The cable is considered as an axially loaded Euler beam. When there is no crack, the dynamic displacement of the robot is smooth and no distortion at the crack position can be inspected. However, when there is a damage in the cable, there is a distortion in the robot displacement at the damage location but this distortion is small and difficult to be observed visually. The distortion caused by the crack is presented as the significant peaks in the wavelet transform of the robot displacement. The proposed method is promising since it is efficient to detect cracks with depth as small as 1% of the cable diameter and to detect local changes in diameter with amplitude as small as 0.1%.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
