Abstract
This paper presents a low-cost experimental technique to carry out damage assessment of structures using dynamic strain measured by of surface-bonded piezo transducers. The technique is applied on a single module tensegrity structure, 1m×1m in size and then extended to a tensegrity grid structure, 2m×2m size, fabricated using galvanised iron (GI) pipes and mild steel cables. A single piezoelectric-ceramic (PZT) patch bonded on a strut measures the dynamic strain during an impact excitation of the structure. Damage is identified from the frequency response function (FRF) obtained after domain transformation of the PZT patch’s response. For the grid structure, damage is localized using changes in the three natural frequencies observed experimentally and the corresponding mode shapes obtained numerically. The technique is found to be very expedient and at the same time cost effective, especially for preliminary damage detection in the structures.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
