Abstract
Ultra-precision cutting experiments were carried out using a single crystal diamond (SCD) tool and a poly crystal diamond (PCD) tool for the finish cutting of the tungsten carbide, in order to investigate the influence of the WC particle size and the cutting conditions on the finished surface quality, As a result, although the ploughed dimples remain on the cut surface by PCD tool, the good surface without the defects was obtained in the case of using PCD tool. Furthermore, with a decrease in WC particle size, the surface quality was improved and the roughness reached to 0.01μm (Ra).
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Proceedings of International Conference on Leading Edge Manufacturing in 21st century : LEM21
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.