Abstract
Γo cut the spiral bevel gear the Gleason's Spiral Bevel Gear Generator is generally used. By the conventional cutting method, however, the machine setting and the cutter used are very complex in spite of the approximate cutting. So it is very difficult to get the accurate spiral bevels. If the Parallel Depth Bevel Gears are cut on the same Generator, many troubles above mentioned are quite swept away, and the cutting mechanism becomes theoretically correct too. So the cutting is performed very securely and we can get easily the good spiral bevels with high accuracy. In this paper the cutting theory of this method and the results of experiments are stated in full.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Transactions of the Japan Society of Mechanical Engineers
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
