Abstract
Strain gauges were mounted on 12 maxillary pre-molars which were subjected to a sequence of restorative procedures for MOD preparations. An occlusal stress was applied using servohydraulics, and the cuspal flexure was assessed using a strain gauge. Two bonded and three non-bonded restorative procedures were tested for each tooth. The two bonded conditions showed significantly higher cuspal reinforcement when compared with the MOD preparation and the non-bonded restorative procedures. The non-bonded restorations showed some intragroup differences, with one non-bonded composite showing useful cuspal reinforcement. However, this was much less than that afforded by the bonded technique. The deformation of the cusp under occlusal force in restorations bonded by the acid-etch technique showed much less hysteresis when compared with non-bonded restorations.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.