Abstract
This paper shows the analysis and design of a parallel-connected converter system using sliding mode control techniques. The design is particularised for a system that consists of N boost converters and a current feedback loop based on a proportional-integral compensator of the output voltage error. The paper emphasises the advantages of the sliding-mode control over the classic design method based on small-signal models, thus providing an effective and robust means of controlling nonlinear multi-input converters. The design is based on the Utkin conditions, which permit us to know the regions under which a sliding mode exists. This fact allows us to design the compensator and to introduce some modifications in the control loop that avoids input-current overshoots during the system startup. Simple design expressions are obtained and verified with simulation and experimental results, thus showing the improvements achieved with the proposed modifications.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.