Abstract
AbstractStudies of the wafer edge uniformity step by step, from hard mask deposition, reactive ion etch, electroplating to post Cu CMP had been done using scanning electron microscopy (SEM) measurements, showed that the major wafer non-uniformity comes from the Cu CMP step. Improvement of Cu CMP edge uniformity had been achieved through engineering of platen 1 using real time profile control as well as CMP head zone pressure adjustment and platen 3 slurry optimizations
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
