Abstract
AbstractTo improve the engine efficiency by increasing the gas temperature, multi-layer cooling passages are applied in new designs of gas turbine blades. As a result, traditional non-destructive methods, which have been applied so far in the production control, became insufficient. The aim of this manuscript is to develop an inspection method for cooling passages of turbine blades, which would be helpful in detecting manufacturing defects of blades and their operational failures. GE v/tome/x/m 300 was applied to conduct dimensional control and check the interior of two types of turbine blades from turboshaft engines. The procedure for selecting X-ray parameters was suggested. The thickness of walls in the selected cross-section was measured with the accuracy of 0.01 mm, and the selected manufacturing defects of cooling passages were identified.
Sign-in/Register to access full text options 
Free) 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call
