Abstract
Abstract Two different types of inorganic silica fillers, nano-silica powder (NSP) and colloidal silica sol (CSS) were added into isotactic polypropylene (iPP) with low silica content (0.2 wt%) and the influence of the two silica fillers on the crystallization behavior and mechanical properties of iPP were investigated. Differential scanning calorimeter (DSC) results showed that the crystallization temperature of iPP with CSS and NSP were increased by 4.1 °C, and 2.4 °C, respectively. The tensile strength, flexural strength, and izod impact strength of iPP/CSS (33.75 MPa, 33.04 MPa, and 4.80 kJ/m2) were higher than that of iPP/NSP (32.09 MPa, 32.27 MPa, and 4.25 kJ/m2). In addition, the haze value of iPP/CSS was decreased from 37.6 % to 27.6 %, which was 4.7 % lower than that of iPP/NSP (32.3 %). The better performance of CSS as ascribed to its better dispersion ability in iPP matrix than NSP, and it was verified by scanning electron micrograph (SEM) and transmission electron microscope (TEM). Overall, these results indicated that inorganic silica sols had a potential application in the nanoparticle-reinforced composites field.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.