Abstract
The control system uses LABVIEW as the software development platform. The system includes ADLINK motion control card PCI-8134, LEETRO stepper motor drivers DMD 402A, and tables with LEETRO DM4240A stepper motors. The system uses ADLINK PCI-8134 to send stepping pulse signal PUL and direction level signal DIR to control the stepper motor's rotation angle and direction, achieving the motor’ positive and negative rotation, acceleration, constant speed and deceleration, then achieving the radial motion of table's Z-axis slider along the surface of the measured part, the axial motion of X-axis slider along the surface of the measured part and the spindle rotation for the measurement of roundness and cylindricity.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.