Abstract
The effects of temperature and solvent on myosin subfragment 1 ATPase have been studied. Under all of the conditions used the data could be fitted to the Bagshaw - Trentham pathway: (formula; see text) Ethylene glycol (40%) was used as the cryosolvent ; this makes K1 and k+2 measurable and allows for temperature studies over an extensive temperature range (+35 to -20 degrees C) and thus to reasonably accurate thermodynamic parameters. The following techniques were used: ATP chase (for K1 and k+2); Pi burst (k+2 or k+3 + k-3); single-turnover Pi burst [k0 = k +4K3 /(1 + K3)] absorption stopped flow (k+2 or k+3 + k-3); steady state (k+6 or k0). Myosin provides examples of causes for nonlinear Arrhenius and van't Hoff plots. A temperature-induced structural change is exemplified by a "jump" in an Arrhenius plot of k+2 and "breaks" in van't Hoff plots of K1 and K3. A change in rate-limiting step is illustrated from stopped-flow experiments ( kobsd approximately k+2 at low and approximately k+3 + k-3 at high temperatures) and steady-state experiments (kcat approximately k+6 at low and approximately k0 at high temperatures). A third cause is illustrated by k0: an Arrhenius plot of k0 is nonlinear since there is a break in K3. These studies illustrate the use of temperature perturbation as a way of revealing reaction intermediates and of defining the conditions required for the isolation of a particular intermediate.(ABSTRACT TRUNCATED AT 250 WORDS)
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.