Abstract

SUMMARY From the S-wave data collected along a 270-km-long profile spanning the Kunlun mountains in NE Tibet, 14595 Sg phase arrivals and 21 SmS phase arrivals were utilized to derive a whole-crustal S velocity model and, together with a previously derived P velocity model, a Poisson's ratio (σ) model beneath the profile. The final tomogram for the upper 10–15 km of the crust reveals the lower velocities associated with the predominantly Neogene-Quaternary sediments of the Qaidam basin to the north and the higher velocities associated with the predominantly Palaeozoic and Mesozoic upper crustal sequences of the Songpan-Ganzi terrane and Kunlun mountains to the south. This study finds no evidence that the Kunlun mountains are involved in large-scale northward overriding of the Qaidam basin along a shallow south-dipping thrust. The σ in the upper 10–15 km of the crust are often lower than 0.25, indicating a preponderance of quartz-rich rocks in the upper crust beneath the profile. Below 10–15 km depth, the remainder of the crust down to the Moho has an average σ of 0.24 beneath the Songpan-Ganzi terrane and Kunlun mountains and 0.25 below the Qaidam basin. These low σ are similar to other low σ found along other profiles in the northeastern part of the plateau. Assuming an isotropic situation and no significant variation in σ between 10–15 km depth and the Moho, then the lower crust between 25–30 km depth below sea level and the Moho with P velocities varying from 6.6 km s−1 at the top to around 6.9 km s−1 at the base and σ of 0.24–0.25 should comprise intermediate granulites in the upper part transitioning to granulite facies metapelites in the lower part. As the pre-Cenozoic Qaidam basin crust has probably not lost any of its lower crust during the present Himalayan orogenic cycle in the Cenozoic and only has a σ of 0.245–0.25, then it appears that the pre-Cenozoic Qaidam basin crust involved in the collision is more felsic and thus weaker and more easily deformable than normal continental crust with a global average σ of 0.265–0.27 and the Tarim and Sichuan basin crusts. This situation then probably facilitates the collision and promotes the formation of new high plateau crust at the NE margin of Tibet. South of the Qaidam basin, the crust of the Songpan-Ganzi terrane and Kunlun mountains has an even lower average crustal σ of 0.23–0.24 and is thus presumably even weaker and more easily deformable than the crust beneath the Qaidam basin. This then supports the hypothesis of Karplus et al. that ‘the high Tibetan Plateau may be thickening northward into south Qaidam as its weak, thickened lower crust is injected beneath stronger Qaidam crust'.

Highlights

  • AND GEOLOGYDuring the International Deep Profiling of Tibet and the Himalaya (INDEPTH) phase IV controlled-source seismic experiment in 2007 June, 949 vertical-component seismographs (IRIS-PASSCAL Texans) at 100–650 m station spacing and 20 broad-band and 29 short-period three-component seismographs (34 from GIPP, Germany and 15 from SEIS-UK) at 5–6 km station spacing recorded five large shots (1000–2000 kg) and 102 small shots (60–240 kg) along a 270-km-long profile across the Kunlun mountains from the Songpan-Ganzi terrane to the Qaidam basin (Fig. 1)

  • The low S velocity anomalies near the North Kunlun Fault (NKF) and South Kunlun Fault (SKF) along the INDEPTH IV profile are probably at least partly because of weakened, damaged rocks associated with the fault zones

  • The average crustal σ beneath the Qaidam basin is close to the global average of 0.265–0.27 for continental crust (Zandt & Ammon 1995; Christensen 1996), the crust below the Cenozoic basin sediments between 1 km depth b.s.l. and the Moho only has an average σ of 0.245–0.25 which is less than the global average for continental crust

Read more

Summary

Introduction

AND GEOLOGYDuring the International Deep Profiling of Tibet and the Himalaya (INDEPTH) phase IV controlled-source seismic experiment in 2007 June, 949 vertical-component seismographs (IRIS-PASSCAL Texans) at 100–650 m station spacing and 20 broad-band and 29 short-period three-component seismographs (34 from GIPP, Germany and 15 from SEIS-UK) at 5–6 km station spacing recorded five large shots (1000–2000 kg) and 102 small shots (60–240 kg) along a 270-km-long profile across the Kunlun mountains from the Songpan-Ganzi terrane to the Qaidam basin (Fig. 1). Following the controlled-source seismic experiment the three-component seismographs were partly redeployed such that 24 broad-band seismographs occupied the central part of the 270-km-long profile across the Kunlun mountains between shots KS2 and KS4 and the other 26 broad-band seismographs extended along a profile across the Jinsha suture between shot KS3 and Tuotuo. This deployment of 50 broadband seismographs to record earthquakes lasted until 2008 September. The relocation was accomplished utilizing the HYPO71PC computer program (Lee & Valdes 1985) and a local 1-D P velocity model, based on an average of an early version of the 2-D P velocity model along the controlled-source profile (Karplus et al 2011)

Objectives
Findings
Discussion
Conclusion

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.