Cross-linking of poly (vinyl alcohol) films under acidic and thermal stress

Abstract

Poly (vinyl alcohol), PVA, a commonly used excipient to coat tablets, forms insoluble films in the presence of acids and thermal stress. This may lead to drug products failing to meet dissolution specifications over time. Studies were conducted to understand the effect of acid strength, processing conditions, and storage stress on the mechanism of insoluble film formation using PVA and OpadryⓇ II as model systems. Aqueous cast films, prepared by incorporating hydrochloric acid (HCl) into the coating solutions or exposing pre-cast “as is” films to HCl vapors, were used as surrogates to develop analytical methods. To understand effect of acid and processing on coatings, acidified OpadryⓇ II was spray coated onto inert cores under “wet” or “dry” conditions. Samples stored at 50-60 °C were analyzed for film disintegration to understand physical/chemical changes in the polymer. Rate and extent of insoluble films formation was dependent on the acid concentration and thermal stress. Analysis of the films indicated significant de-acetylation and ether bond formation in insoluble aqueous cast films. In contrast, acidified coated films showed only ether bond formation, which increased on stress, forming insoluble films. The reduction in the time to form insoluble films for “wet” versus “dry” coated films was rationalized by considering effect of coating, drying, and storage on the microstructure of acidified PVA and ether bond propagation. The results highlight the need to develop an in-depth understanding of the design space for PVA coated products and storage conditions in presence of acids.