Critical investigation of high temperature gas nitriding of a PM tool steel

Abstract

AbstractThe nitrogen uptake of high-alloyed steels, especially tool steels, from gaseous atmospheres at elevated temperatures is a well known effect. Besides, for instance, the nitrogenbased case hardening, one application arises in the field of powder metallurgy. Here, introducing nitrogen containing atmospheres during sintering of high-alloyed powder metallurgically produced tool steels could lead to an optimization of the sintering process and an improvement of the materials properties. In this context, several works deal with the application of computational thermodynamics for considering the nitrogen uptake. The scope of this contribution is to investigate in detail the agreement of calculated and experimentally found nitrogen contents. Therefore, one typical gas-atomized powder of a ledeburitic cold work steel was sintered at a temperature of 1230°C, varying the nitrogen partial pressure during sintering between 0.02 MPa and 0.2 MPa. The measured nitrogen contents are compared with values obtained from equilibrium calculations. Additionally, the distribution of nitrogen in the microstructure is investigated by time-resolved optical emission spectrometry and energy dispersive X-ray spectrometry measurements. The results exhibit good agreement between calculated and measured values for low partial pressures of less than 0.1 MPa and an increasing deviation for higher partial pressures. Furthermore, the transformation of vanadium-containing MC carbides to M(C, N) carbonitrides was verified.