Abstract
Crtical heat flux (CHF) is an important characteristic of nanofluids. The CHF measurements were carried out in nanofluid research at the Center for Applied Nuclear Science and Technology. These measurements are done manually using a variable power supply and a multimeter. However, it was difficult to record the voltage and current due to the sudden break of the wire. In this study, Arduino was used to measure CHF automatically. The voltage is applied to the wire and increases automatically along with the measurement of the voltage and current in the wire. The results of the voltage and current measurements were compared with a multimeter and were not significantly different. It can be concluded that the CHF measurement system using arduino can be used to measure nanofluid CHF.
Published Version (
Free)
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
