Abstract

Critical heat flux experiments were performed with an alternate high and low heat flux profile in an internally heated annulus. The heated length was 84 inches (213 cm) with a chopped wave heat flux profile over the last 24 inches (61 cm) having a maximum-to-average heat flux ratio of 1.26. Three test sections were employed: one with an axially uniform heat flux profile as a base case and two with 60 inch (152 cm) uniform and 24 inch (61 cm) alternating high and low heat flux sections. The third test section had a 2.15 inch (5.46 cm) section with a peak-to-average heat flux ratio of 2.19 (hot patch) superimposed at the exit end of the alternating high and low heat flux profile.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.