Creating Nature-Inspired Surface Roughness and Modifying Surface Chemistry of PVDF Electrospun Fibers Using Low-Pressure Plasma towards Omniphobic Membrane for Long-term Distillation

Abstract

Today, water scarcity as one of the world's most pressing challenges, has caused many concerns. Seawater desalination based on membrane distillation (MD) has been introduced as an effective solution to deal with this problem. The surface of membranes used in MD is required to be modified to guarantee long-term performance via creating resistance against membrane wetting by low surface tension feeds. In this regard, beetle skin-inspired roughness was created on the surface of poly(vinylidene fluoride) (PVDF) electrospun fibers using low-pressure plasma technique. Synergistically, 1H, 1H, 2H, 2H-perfluorooctyl acrylate (PFOA) was polymerized on the fiber surface to modify its chemistry. In other words, using the plasma polymerization technique, the membrane surface energy was reduced thanks to (1) the increase in membrane surface roughness and (2) the change in the membrane surface chemistry, as confirmed by field-emission scanning electron microscope (FESEM) imaging, X-ray photoelectron spectroscopy (XPS) and Fourier-transform infrared-attenuated total reflectance (FTIR-ATR) spectroscopy. These changes led to an omniphobic membrane repelling water, engine oil and isopropanol with contact angles of 150°, 135°, and 119°, respectively. The long-term performance of the developed omniphobic membrane was demonstrated by conducting air gap membrane distillation (AGMD) for a duration as long as 600 min using a feed solution containing 3.5 wt% NaCl and 0.6 mM sodium dodecyl sulfate (SDS), which is ten times better than the performance of pristine membrane (60 min). Overall, the surface modification technique considered in this work yields an omniphobic membrane with stable long-term performance without compromising the membrane flux and salt rejection.