Crash Testing and Evaluation of Culvert-Mounted Midwest Guardrail System

Abstract

Concrete box culverts are usually installed under roadways to allow water drainage without affecting the motoring public. Culvert openings can represent a hazard on the roadside when they do not extend outside of the clear zone, and often require safety treatments in the form of roadside barriers. In this study, a modified design of Midwest Guardrail System (MGS) was evaluated for installation on a low-fill culvert with the strong-post attachment using through-bolts and epoxy anchorage through full-scale crash testing. The test installation consisted of MGS with a 31 in. top rail height, supported by W6 × 9 posts, spaced at 37½ in., attached to a low-fill culvert’s top slab with a 12 in. offset from the back of the post to the culvert headwall. Two crash tests were conducted according to the American Association of State Highway and Transportation Officials’ (AASHTO) Manual for Assessing Safety Hardware (MASH) 2016 Test Level 3 impact safety criteria. In test number CMGS-1, a 2,428-lb car impacted the MGS attached to the culvert at a speed of 61.3 mph and at an angle of 25.1°. In test number CMGS-2, a 5,013-lb pickup truck impacted the MGS attached to the culvert at a speed of 62.8 mph and an angle of 25.7°. In both tests, the vehicle was safely redirected and captured. Both tests were deemed acceptable according to TL-3 safety criteria in MASH. Recommendations were made for the safe installation of MGS atop low-fill culverts as well as transitions from the standard MGS to the culvert-mounted MGS.