Abstract
To gain a better understanding of the cracking process and failure mode of rock mass with a set of coplanar non-persistent joints, the uniaxial compression tests were carried out for 15 cylindrical rock-like specimens with different joint inclination angles (α) and rock bridge lengths (Lr) prepared through a self-developed method. Results obtained from the laboratory experiments are as follows, (1) five types of failure modes of specimens are observed: tensile failure mode (T-mode), tensile dominated tensile/shear complex failure mode (TDM-mode), tensile/shear equally complex failure mode (TSEM-mode), shear dominated tensile/shear complex failure mode (SDM-mode) and shear failure mode (S-mode); (2) The failure mode of specimen is T-mode or TDM-mode at α = 15°, and that of specimen is S-mode and SDM-mode at α = 60°; and the transitional failure modes occur as α increases from 15° to 60° and from 60° to 75°; (3) a greater Lr will strengthen the tension effect and mitigate the shear effect on the failure of specimen; in general, the representative value of failure mode increases as Lr increases from 10 to 30 mm. Numerical modeling by the discrete element method efficiently simulates the cracking process and fracturing behavior of the five types of failure modes in laboratory experiments.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.