Crack separation mechanism in CO2 laser machining of thick polycrystalline cubic boron nitride tool blanks

Abstract

An improved method for cutting thick polycrystalline cubic boron nitride (PCBN) tool blanks is explored because current methods of pulsed Nd:YAG laser cutting and wire electrical discharge machining (EDM) are constrained by low speed and low precision. We present a CO2 laser/waterjet (LWJ) process to cut 4.8-mm-thick PCBN tool inserts by a crack separation mechanism. In LWJ, the PCBN blank is locally heated using a high-power continuous wave CO2 laser to cause phase transition from cubic to hexagonal followed by water quenching to generate thermal stresses and form boron oxide leading to increased brittleness, subsequent cracking, and material separation. A 23 fractional design of experiment (DOE) approach was employed to determine the factors of laser power, cutting speed, and waterjet pressure on the responses of phase transformation depth, taper, and surface roughness. A numerical heat flow model, based on Green’s function, was used to calculate the temperature distributions along the depth. Surface profilometer, scanning electron microscopy, and Raman spectroscopy were utilized to analyze the phase transformation and crack zones. Results from LWJ compared with pulsed Nd:YAG laser and laser microjet™ methods indicate LWJ cuts 30 times faster; this was attributed to a nonconventional material removal (crack separation) mechanism. When LWJ was compared against nitrogen-assisted CO2 laser cutting, improved cut quality (less taper and smaller heat-affected zone) was observed due to a greater control on phase transformation and crack propagation. DOE analysis revealed laser power and waterjet pressure, and the interactions among them are more significant factors than others.