Crack growth angle prediction of an internal crack under mixed mode load for unfilled elastomer using the strain energy density factor

Abstract

ABSTRACTThis article investigates the prediction of the crack growth angle of an existing internal crack under mixed mode loading at the crack tip for an unfilled ethylene propylene diene terpolymer rubber (EPDM). For the realization of mixed mode loading, the cracks of the uniaxial loaded specimens were oriented with different angles to the loading direction. The energy density factor was used as a potential criterion for determining the crack growth angle. The determination of the strain energy density factor was carried out simulatively in Abaqus. The second‐order Ogden model was used to describe the rubber‐like material behavior. The relative local minimum of the strain energy density factor provides the possible growth angle. The experimental investigations show that the initial cracks grow orthogonally to the loading direction for the different crack orientation angles. For the crack orientation angle parallel to the load direction, the crack growth was observed because the strong stretching of the specimen caused strong necking in the crack region. The crack growth for the remaining crack orientation angles were induced due to shear loading at the crack tip. The predictive angle of different crack orientation angles shows very good accordance to the measured crack growth angles.