Coupled Effect of Filler Content and Countersurface Roughness on PTFE Nanocomposite Wear Resistance

Abstract

In tests of PTFE with 2.9% volume content alpha-phase alumina nanoparticles (40 or 80 nm) in sliding reciprocation against polished steel, wear rates of ~10−7 mm3/Nm were measured which is four orders-of-magnitude lower than unfilled PTFE and two orders-of-magnitude lower than with microparticles (0.5 or 20 μm) of more conventional filler size. This was similar to that previously reported in unidirectional sliding, and did not vary greatly with stroke of reciprocation. For a microfilled PTFE, the wear rate gradually increased towards that of unfilled PTFE as filler content was reduced, whereas nanofilled PTFE maintained relatively constant ~10−7 mm3/Nm to filler contents as low as 0.18% before reverting towards the rapid wear rate of unfilled PTFE. Lightly filled nanocomposites depend upon low countersurface roughness to maintain such low wear rate, and with increasing roughness the wear rate was found to transition at a critical value to a wear rate of ~10−5 mm3/Nm. Nanocomposites with higher filler contents were able to retain the low wear rates against rougher countersurfaces, as the critical roughness at which this wear resistance was lost tended to increase with the square of the filler content. Upon encountering extremely high countersurface roughness in the range R a = 6–8 μm, nanocomposites at each filler content eventually increased in wear rate to ~10−4 mm3/Nm. The steel countersurface did not appear to play an important role in the extreme wear resistance of these alumina nanofilled PTFE composites, as comparable performance was also displayed against alumina countersurfaces.