Abstract
A counting signal processing technique of the fiber-optic interferometric sensor is proposed. The technique is capable of counting the numbers of the maximum and minimum of the output interferometric signal in a specific time duration, and it can be used as the basis to distinguish the sensing phase signal. It can also be used as a signal detector on applications such as intrusion detection. All sensors are subject to aging of the optical components and bending loss, and therefore the output signal of each sensor may vary with time. We propose a counting level normalization technique to compensate for these variations and to obtain the correct counting numbers.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.