Abstract
Abstract In this article presented results of researching corrosion of steel bars in aggressive environment in time under loading. For researching were used special equipment. The experience and research works shown that steel bars in the crack cross-section area can be corrode. With increasing width of crack in re-bars and power of aggressive of environment increased the level of corrosion and decreased time of progress. The level of danger of corrosion in the crack in depend of specialty of steel bars. It is geometry parameters of steel bars and characteristic of corrosive behaviour. The general tendency of the influence of various defects on the strength of steels is widely studied experimentally and theoretically only for geometrically correct stress concentrators. For damages that are irregular in shape, such as corrosion ulcers, significantly less researching in each case must experiment to find their effect on the mechanical properties of steels. In this work the influence of simultaneous action of the aggressive environment and loading on strength of steel re-bars has been described.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: System Safety: Human - Technical Facility - Environment
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
