Corrosion of nickel-base and iron-base alloys in a simulated fluidized-bed coal-combustion environment

Abstract

The modes of initiation and propagation of corrosion attack on a series of high-temperature alloys were studied in synthetic gas mixtures at 900°C. The gas mixtures were intended to simulate the oxygen and sulfur partial pressures experienced in reducing zones in a coal-fired fluidized-bed combustor and comprised mixtures of CO, CO2, and SO2. The alloys studied were candidates for in-bed heat exchanger tubing for an air-heater cycle operating at 843°C and 300–500 psig and so ranged from type 300-series stainless steels to nickel-base alloys. With the exception of two FeCrAlY alloys and types 304 and 347 stainless steels, it was found that sulfidation corrosion could be initiated on all the alloys within 0.25 hr; the rate of propagation of the corrosive attack depended on the flux of SO2 in the environment and on the nickel content of the alloys. The presence of iron in the alloys appeared to slow the initiation of sulfidation, by forming a continuous iron oxide layer. The effects of various alloying additions are discussed, and a schematic model for the initiation of sulfidation is proposed.