Corrosion of copper nickel titanium archwire in chlorhexidine, sodium fluoride, and chitosan mouthwashes.

Abstract

Background: Copper (Cu), nickel (Ni), chromium (Cr) ion release, and surface topography change from the orthodontic wire are the initial processes of corrosion that may affect the mechanical properties of the archwire. In this study, we aim to evaluate the effect of CHX, NaF, and chitosan on the corrosion of CuNiTi wire nickel and copper ions released, surface roughness change, and archwire deflection. Methods: Ninety samples of CuNiTi Tanzo™ archwires were divided into five groups according to their immersion solution: Artificial Saliva, CHX, NaF, CHX-NaF, and chitosan group. Each group was further divided into three subgroups (n=6) corresponding immersion time, i.e., two, four, and six weeks. The corrosion of the samples was analyzed with an atomic absorption spectrophotometer (AAS), scanning electron microscope (SEM), and universal testing machine (UTM). Results: The amount of nickel ion releases was increasing, but the copper ion releases were reduced by the time of observations. The highest nickel ion was released in the CHX-NaF group and the lowest in the chitosan group for six-week immersion. It also corresponded to the surface topography by SEM analysis which showed the most extended cracks and deep pits in the CHX-NaF group and a smoother surface in the chitosan group. Copper ion release showed the highest ion release in the NaF group and the lowest release in the chitosan group. The unloading force of CuNiTi archwire deflection remains the same at week two and week four for all mouthwashes. Conclusion: The use of mouthwashes that contained CHX, NaF, and chitosan could further alter the passive layer and cause higher nickel and copper ion release and increased CuNiTi archwire surface structure porosity. But there is no distinction between mouthwashes to release the unloading force within two until four weeks.