Abstract

Carbon steels composed by two main elements, they are iron (Fe) and carbon (C) elements which widely used in industrial because of its resistance and more affordable than stainless steel, but their weakness is they have low corrosion resistance. One way to modify carbon steel is by coating them with antioxidant compounds that can delay, slow down, and prevent lipid oxidation process, which obtained from onion peel extract. Several studies on corrosion inhibitors have been performed. However, the efficiency was not reach the optimum. This study aims to examine the effect of onion peel extract concentration on the efficiency of corrosion inhibitor and characterization of the green corrosion inhibitor from onion peel extract. This research method begins by extracting onion peel to 200 ml solvent which we use aquadest and methanol and mixed with 5 grams of crushed onion peel, then let them be extracted for 60 minutes with room temperature. Once it was filtered and the solution obtained, followed by evaporating process with rotary evaporator to decrease the content of solvent. The product is ready to be used as a green corrosion inhibitor of carbon steel in 1 mol/L HCl. While the analysis used is HPLC qualitative analysis, and electroplatting process. The impedance is measured at a frequency of 100 kHz to 4 mHz with an AC current of 10mV. Inhibitor concentrations are vary between 2 ml and 4 ml of onion peel extract. Electroplatting is done within 30 minutes with 10 minutes each checking time. Furthermore, quantitative analysis was done for the analysis of corrosion rate and weight loss. Based on HPLC analysis, it is known that the extract of onion peel contains 1mg/L of quercetin, which is belong to flavonoid group as green inhibitor. While electroplatting process, aquadest solvent having average efficiency of 99,57% for 2 ml of extract, and 99,60% for 4 ml of extract. Methanol solvent having average efficiency of 99,52% for 2 ml of extract and 99,74% for 4 ml of extract. In line, methanol have more possibilities to gain flavonoid out to act as green inhibitor than aquadest due to its polarity. It is suggested to cover up the extract of onion peel to avoid them against sunlight, to keep the flavonoid not damaged.

Highlights

  • Carbon steels composed by two main elements, they are iron (Fe) and carbon (C) elements which widely used in industrial because of its resistance and more affordable than stainless steel, but their weakness is they have low corrosion resistance

  • The product is ready to be used as a green corrosion inhibitor of carbon steel in 1 mol/L hydrogen chloride (HCl)

  • It can be seen the value of the efficiency of corrosion rate with and without inhibitors of onion peel extract with various solvents

Read more

Summary

Introduction

Carbon steels composed by two main elements, they are iron (Fe) and carbon (C) elements which widely used in industrial because of its resistance and more affordable than stainless steel, but their weakness is they have low corrosion resistance. The product is ready to be used as a green corrosion inhibitor of carbon steel in 1 mol/L HCl. While the analysis used is HPLC qualitative analysis, and electroplatting process. Inhibitor concentrations are vary between 2 ml and 4 ml of onion peel extract. Based on HPLC analysis, it is known that the extract of onion peel contains Aquadest solvent having average efficiency of 99,57% for 2 ml of extract, and 99,60% for 4 ml of extract.

Objectives
Results
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call