Abstract
AbstractFatigue corrosion phenomenon is a form of degradation that is because of the combined occurrence of a mechanical cyclical stress and a corrosive environment. Fatigue corrosion can be an issue in commercial and military aircraft, and has the potential to affect the structural integrity and the useful life of an aerostructure. Although the distinct consequences of both fatigue and corrosion have been extensively documented for aluminum alloys, their synergistic action is not completely understood and continues to be an area of considerable scientific and industrial interest. In this paper, a novel approach is proposed and applied for monitoring the electrochemical behavior of different types of aluminum alloy samples while they are subjected to fatigue loading. Cyclic load experiments were conducted on bare 2024T3 and 6056T4 aluminum alloy samples in the presence of an aggressive aerated solution of 3.5% NaCl over a range of frequencies. The R‐ratio was 0. Two different aluminum alloys have been tested in both high‐ and low‐cycle fatigue. In the former case, the maximum stress experienced by the specimen is lower than the material yield strength, which means that the average expected number of cycles to failure is high; in the latter case, the maximum stress experienced by the specimen during the test is higher than the material yield strength, which means that the average expected number of cycles to failure is low. The open circuit potential(OCP) was monitored versus time during the tests described above. The observed OCP variations are interpreted as the occurrence of corrosion during crack initiation and propagation at the air formed oxide/solution interface film. As expected, there is a more pronounced influence of corrosion at lower fatigue frequencies. Crack propagation allows bulk material to be progressively more exposed to the aggressive environment, which stimulates accelerated crack propagation, resulting in a lower fatigue resistance. Copyright © 2010 John Wiley & Sons, Ltd.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have