Abstract
Abstract Binary magnesium alloys containing chromium, manganese, or titanium were made using a physical vapour deposition technique. The corrosion resistance of the alloys was assessed in aqueous chloride solutions using total immersion tests in quiescent 600 mmol L−1 NaCI solutions. Alloying with manganese or titanium was found to lower the corrosion rate of magnesium over most of the compositional ranges of interest, whereas addition of chromium had a detrimental effect on the corrosion resistance of magnesium. The lowest corrosion rate was recorded for a Mg–Ti alloy where the value obtained was about 80 times lower than that found for vapour deposited pure magnesium. Open circuit corrosion potential measurements conducted in 600 mmol L−1 NaCl solution showed that additions of chromium, titanium, and manganese also produced deposits which were significantly more noble than pure magnesium, suggesting that these alloys would be less susceptible to galvanic corrosion.MST/3064
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
