Correlation of Material Properties and Open-Circuit Voltage of Amorphous Silicon Based Solar Cells

Abstract

AbstractCorrelation of hydrogenated amorphous silicon (a-Si:H) alloy material properties and solar cell characteristics have been studied experimentally and by computer simulation. Simulation results show that all three solar cell parameters, short-circuit current density (Jsc), open-circuit voltage (Voc), and fill factor (FF), decrease with increased defect density. For a given intrinsic layer thickness, a larger band gap (Eg) results in a higher Voc but a lower Jsc. However, FF does not depend on band gap. This allows us to distinguish the effect of change in band gap from that in defect density on the variation in Voc. For solar cells with good interface characteristics, a linear relation FF = βVoc + γ is obtained by light soaking experiments and simulation with different defect densities. The slope β is in the range from 2 to 3 V-1 depending on cell properties and light soaking condition, and the intersect γ depends mainly on the band gap. Comparing cells made with high H2 dilution to no H2 dilution, we find that a 58 mV enhancement in Voc with H2 dilution is due to both widening of band gap and reduced defect density. Simulation results also show that a narrower valence band tail leads to a higher Voc. We did not include this effect in the analysis due to lack of available data for correlation between H2 dilution and band tail narrowing.