Abstract
The necessity of taking into account the barreling effect at the design of die cavities, and open die and closed die forging processes on the basis of pre-forming of billets by upsetting is shown. The division of ideas about the indices of “bulk” and “linear” barreling (barrel shape), which is determined by the ratio of the bulk and linear dimensions of the workpiece after upsetting by flat dies, was made. The functional relation (correlation) between these indices and the friction coefficient on the boundary surface between flat dies and the upsetted workpiece has been determined. The qualitative and quantitative effect of workpiece dimensions (diameter-to-height ratio), strain range, temperature (conditions of cold and hot processing) and type of forming material (structural carbon steel, some of Cu-grades and Al-grades) on the barreling effect and friction coefficient during upsetting was found. The developed method makes it possible to predict a change in the friction coefficient during the upsetting of various material workpiece under given conditions of forming and to monitor their effect to the final shape.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
