Correlation between the size of released titanium particles and changes in the surface of dental implants during insertion into bone blocks: an in vitro study.

Abstract

This study investigated the size and amount of titanium particles immediately released following dental implant insertion into bovine bone blocks and aimed to correlate them with the surface roughness of the implants. Twelve bone blocks were prepared from bovine mandibles. Six tapered (group A) and 6 cylindrical (group B) dental implants were inserted into the bone blocks under water irrigation, following the standard drilling protocol. After insertion, the implants were immediately removed from the bone. Scanning electron microscopy (SEM), energy-dispersive X-ray spectroscopy (EDX), and atomic force microscopy were performed to investigate the released titanium particles and implant surface roughness, respectively. The amount of titanium ions in the irrigation water was measured using inductively coupled plasma mass spectrometry. Dynamic light scattering (DLS) was used to determine the size range of the released titanium particles. The percentages of titanium content on the surface of implants decreased in both groups after implantation into bone blocks. SEM-EDX analysis confirmed the presence of titanium particles embedded in the implanted bone bed. Group B implants showed significantly higher concentrations of titanium ions in the collected water than group A implants (0.868 and 0.565 µg/L, respectively). Group A implants demonstrated high pre-implantation surface roughness, which led to a much greater decrease in post-implantation surface roughness than was observed for group B implants. DLS analysis showed that the titanium particles released from group A implants were within the nano-size range, whereas those released from group B implants were within the micro-size range. Dental implant placement leads to a decrease in implant surface roughness and the immediate release of titanium particles into the peri-implant bone. Variations in the size range and amount of released particles were correlated with implant surface roughness. This finding has clinical implications and warrants additional in vivo studies.