Correlation Between Dynamic Spray Plume and Drug Deposition of Solution-Based Pressurized Metered-Dose Inhalers.

Abstract

Listen

Translate article

Background: The lack of visual dynamic spray characterization has made the understanding of the physical processes governing atomization and drug particle formation difficult. This study aimed to investigate the changes in the spray plume morphology and aerodynamic particle size of solution-based pressurized metered-dose inhalers (pMDIs) under different conditions to achieve better drug deposition. Methods: Solution-based pMDIs were studied, and the effects of various factors, such as propellant concentration, orifice diameters, and atomization chamber volume, on drug deposition were examined by analyzing the characteristics of spray plume and aerodynamic particle size. Results: Reducing the actuator orifice and spray area led to a concentrated spray plume and increased duration and speed. Moreover, the aerodynamic particle sizes D50 and D90 decreased, whereas D10 remained relatively unchanged. Decreasing the atomization chamber volume of the actuator led to reduced spray area and an increased duration but a decreased plume velocity. D90 exhibited a decreasing trend, whereas D10 and D50 remained relatively unchanged. Reducing the propellant concentration in the prescription, the spray area and the plume velocity first decreased and then increased. The duration initially increased and then decreased. The values of D50 and D90 showed an initial decreasing followed by an increasing trend, whereas D10 remained relatively unchanged. Conclusions: During the development process, attention should be paid to the changes in the spray area, spray angle, duration, and speed of the spray plume. This study recommended analyzing the characteristics of the spray plume and combining the data of two or more aerodynamic particle size detection methods to verify the deposition in vitro to achieve rapid screening and obtain high lung deposition invivo.