Correcting the distortion of apparent resistivity pseudosection produced by 3D effect of the embankment geometry

Abstract

Two-dimensional electrical resistivity tomography data acquired on the crest of the embankment are distorted by the 3D effect of the embankment geometry, reservoir water level and abutment. The distortion affects seriously the final solution of the 2D inverse problem. By comparing the apparent resistivity pseudosections from a 3D and 2D electrical resistivity model of the embankment, the distortion degrees of the apparent resistivity pseudosections along the axis on the crest were estimated for the cases of reservoir and which does not contain water. The obtained results indicate that the distortion degree acquired in the case of a reservoir that contains water was much less than that in the case of the reservoir that does not contain water. In the case of reservoir that contains water, the apparent resistivity pseudosections of the P–P and ED–ED arrays had the largest distortion degree and of D–D, W–S and P–D arrays had the smallest distortion degree. In the case of the reservoir that does not contain water, the apparent resistivity pseudosection of P–P array had the smallest distortion among all arrays. Through modeling investigation, a correction process to reduce the distortion of the apparent resistivity pseudosection was proposed. The correction process was tested in the embankment model, and two field works were carried out in the To Lich River in Hanoi and Khuan Cat embankment in Lang Son province, Vietnam. It is possible to bring the distortion of the apparent resistivity pseudosection down to 2.8–13.9%, depending on the type of electrode arrays and the type of reservoirs, containing or does not contain water. The distortion correction of the apparent resistivity pseudosection is strongly recommended before doing the 2D inverse interpretation.