Abstract
Abstract The distinctive geology of the Weyburn and Midale reservoirs has important implications for the design of a CO2 injection process for these fields. They are contained within two distinct zones of the Mississippian Carbonate formation; the tight, high-porosity Marly zone sits on top of the low-porosity Vuggy zone. The latter zone has a higher permeability, and is more extensively fractured vertically, than the Marly zone. These geological features result in a relatively unswept Marly zone after waterflooding. The Marly/Vuggy sequence presents an opportunity for a CO2 flood to take advantage of gravity segregation to recover the large remaining oil target in the Marly zone. A series of coreflood tests were conducted to simulate tertiary CO2 injection in the Marly/Vuggy zones in the Weyburn and Midale reservoirs. Berea cores with different permeabilities were split lengthwise. The halved segments of the core were butted together to represent the Marly and Vuggy zones. Water (in waterflood mode) and CO2 (in tertiary CO2 flood mode) were injected into the bottom high-permeability section of the dualpermeability core. The coreflood results showed that, in the tertiary CO2 flood, CO2 could migrate to and recover the oil from the top low-permeability zone which was poorly swept by the waterflood. Also, the effects on tertiary oil recovery of operating pressure, injection rate, and permeability contrast could be significant. Introduction The Weyburn and Midale reservoirs in southeast Saskatchewan hold light and medium gravity oil in fractured, low permeability Midale Beds. These reservoirs are contained within two distinct zones of the Mississippian Carbonate formation: the tight, highporosity Marly zone sits on top of the low-porosity Vuggy zone. The latter zone has a higher permeability, and is more extensively fractured vertically than the Marly zone. These geological features result in a relatively unswept Marly zone after waterflooding. It is believed that the distinctive geology of these reservoirs has important implications for the design of a CO2 injection process for these fields, i.e., the Marly-Vuggy arrangement of the reservoir offers potential to utilize gravity segregation effects to enhance oil recovery. Numerical analyses(1, 2) of tertiary CO2 injection in these naturally fractured reservoirs showed that CO2 injected into the lower, more permeable Vuggy zone can contact and mobilise a large amount of oil in the Marly, which has remained relatively unaccessed by waterflooding. A coreflood program was designed at Saskatchewan Research Council (SRC) to address the CO2 injection process in Weyburn reservoir and comparable fields. Laboratory core displacement tests were conducted with a dual permeability split Berea core representing the Marly and Vuggy zones of a reservoir. Some preliminary results reported in a previous paper(3) showed that CO2 injected into the Vuggy zone could rise to the upper Marly zone, and that the potential to recover incremental oil by a tertiary CO2 slug flood is high. After the technique of butting the core halves was improved, the several additional tertiary CO2 coreflood tests reported here were performed with Weyburn reservoir fluid at 63 ° C (reservoir temperature) to confirm the previous finding.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.