Abstract

Manganese oxides are widespread in soils and natural waters, and their capacity to adsorb different trace metals such as Co, Ni, or Zn is well known. In this study, we aimed to compare the extent of trace metal coprecipitation in different Mn oxides formed during Mn(II) oxidation in highly concentrated, metal-rich mine waters. For this purpose, mine water samples collected from the deepest part of several acidic pit lakes in Spain (pH 2.7–4.2), with very high concentration of manganese (358–892 mg/L Mn) and trace metals (e.g., 795–10,394 µg/L Ni, 678–11,081 µg/L Co, 259–624 mg/L Zn), were neutralized to pH 8.0 in the laboratory and later used for Mn(II) oxidation experiments. These waters were subsequently allowed to oxidize at room temperature and pH = 8.5–9.0 over several weeks until Mn(II) was totally oxidized and a dense layer of manganese precipitates had been formed. These solids were characterized by different techniques for investigating the mineral phases formed and the amount of coprecipitated trace metals. All Mn oxides were fine-grained and poorly crystalline. Evidence from X-Ray Diffraction (XRD) and Scanning Electron Microscopy coupled to Energy Dispersive X-Ray Spectroscopy (SEM–EDX) suggests the formation of different manganese oxides with varying oxidation state ranging from Mn(III) (e.g., manganite) and Mn(III/IV) (e.g., birnessite, todorokite) to Mn(IV) (e.g., asbolane). Whole-precipitate analyses by Inductively Coupled Plasma-Mass Spectrometry (ICP-MS), Inductively Coupled Plasma-Atomic Emission Spectrometry (ICP-AES), and/or Atomic Absorption Spectrometry (AAS), provided important concentrations of trace metals in birnessite (e.g., up to 1424 ppm Co, 814 ppm Ni, and 2713 ppm Zn), while Co and Ni concentrations at weight percent units were detected in asbolane by SEM-EDX. This trace metal retention capacity is lower than that observed in natural Mn oxides (e.g., birnessite) formed in the water column in a circum-neutral pit lake (pH 7.0–8.0), or in desautelsite obtained in previous neutralization experiments (pH 9.0–10.0). However, given the very high amount of Mn sorbent material formed in the solutions (2.8–4.6 g/L Mn oxide), the formation of these Mn(III/IV) oxides invariably led to the virtually total removal of Co, Ni, and Zn from the aqueous phase. We evaluate these data in the context of mine water pollution treatment and recovery of critical metals.

Highlights

  • Coupled Plasma-Atomic Emission Spectrometry (ICP-AES), and/or Atomic Absorption Spectrometry (AAS), provided important concentrations of trace metals in birnessite, while Co and Ni concentrations at weight percent units were detected in asbolane by SEM-EDX

  • Mineral Composition Revealed by X-Ray Diffraction and Electron Microscopy

  • The major mineral phases identified in the Mn precipitates obtained during the batch reaction experiments of Mn(II) oxidation, as identified by X-Ray Diffraction (XRD) and SEM, are illustrated in Figures 2 and 3, and summarized in Tables 2 and 3

Read more

Summary

Introduction

The potential of manganese oxides to retain many different trace metals from natural and engineered environments is well known and has been recognized in very different settings [1,2,3,4].Among over 30 different manganese oxide minerals with a MnOx -like formula, birnessite and todorokite are the most profusely studied by their high adsorbing capacity for trace metals like Ni, Co, or Zn [5,6,7,8,9,10,11,12,13,14,15,16,17,18].Minerals 2019, 9, 226; doi:10.3390/min9040226 www.mdpi.com/journal/mineralsIn small quantities, these trace metals are micronutrients and necessary to sustain life [19].at very high concentrations they become poisonous and can be harmful for aquatic life, as well as for animals and humans [20,21,22]. In small quantities, these trace metals are micronutrients and necessary to sustain life [19]. Ni and Co are critical raw materials and their use in corrosion-resistant metallic alloys, batteries, catalysis, and metal coatings, make them highly valuable in the modern industry [23]. Their current prices (as for January 2019) are several times higher than those of other base metals

Objectives
Methods
Results
Conclusion

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.