Abstract
The high-speed jet discharged by hand dryers with brushed motors may release hazardous particles. In this study, the particles released from the hand dryer were trapped using high-efficiency particulate air filters for chemical composition analysis in a small test room. A manikin was placed to mimic a user standing in front of the dryer. Number and mass concentrations of the released particles were measured to estimate the particle emission rates and inhalation exposure. The particle emission rate reached 2.64 × 106 particles/s when starting the dryer. The released particles were found to contain a copper element, subsequently extrapolated to copper oxide. Secondly, in the large test room, jet airflows were measured using a three-dimensional ultrasonic anemometer. The results revealed that the horizontally placed palms caused the discharged jets to bend toward the human body, resulting in an upward motion of the air into the breathing zone. After running the dryer for 30 s, the peak mass concentration in the breathing zone for particles with a less than 2.5-μm diameter was 13.1 µg/m3. Installing high-efficiency particulate air filters to the air outlets of hand dryers was found to be effective in minimizing the exposure to CuO.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
