(Co)polyimides from commonly used monomers, and their nanocomposites

Abstract

Abstract Synthesis of (co)polyimides from aromatic dianhydrides (pyromellitic dianhydride (PMDA), symmetric 3,3′,4,4′-biphenyltetracarboxylic dianhydride (sBPDA)) and diamines (4,4′-oxydianiline (ODA), p-phenylenediamine (PDA)) commonly used for the production of commercial polyimides, as well as the preparation of their nanocomposites with SiO2 nanoparticles were performed with the aim to find ways to control technical performance of polyimides. The (co)polyimide films prepared under mild thermal imidization conditions were analyzed by FTIR, WAXD, DSC and TG, and characterized by transition temperatures and the temperatures of 5% and 10% mass loss, as well as tensile parameters. Films of PMDA/sBPDA–ODA copolyimides at the ambient temperature had a 20% higher ultimate strength and exhibited a higher tensile modulus than the reference polyimide (PMDA–ODA). However, lowering the transition temperature of the polyimide by partial substitution of an sBPDA monomeric unit for PMDA resulted in lowering the modulus at higher temperatures. The best performance was exhibited by semi-crystalline films of sBPDA–ODA/PDA copolyimide, which had a 35% higher ultimate strength and a 64% higher elongation at break at the ambient temperature than the reference polyimide (sBPDA–PDA), and also retained the strength and exhibited a 200% higher elongation at a temperature of 200 °C. Unexpectedly, the elongation at break of PMDA–ODA based (co)polyimide nanocomposites with hydrophobic SiO2 nanoparticles was greater than that of the baseline (co)polyimides. It was neither the case with PMDA–ODA nanocomposites with hydrophilic SiO2 nanoparticles, nor with sBPDA–PDA (co)polyimide based nanocomposites with hydrophobic SiO2 nanoparticles.