Abstract
The surges protection in low-voltage AC power circuits is commonly realized by Surge Protective Devices (SPDs). These devices divert a large amount of the surge energy to the ground and reduce the surge voltage to the level acceptable for protected device(s). Adequate protection performances are provided by applying multiple-stage protection assuming cascade deployment of SPDs starting from distribution board toward equipment in an installation. Therefore, SPDs coordination, (i.e. selection of SPDs parameters as well as determination of necessary distance between stages) becomes of great importance and the paper deals with this issue. The proper SPDs coordination is significant for both protected equipment and SPDs themselves (their survival during surges). The paper provides an analysis of the SPDs coordination for case of two-stage protection system. The influence of different lengths of cables between protection stages, as well as influence of type and parameters of load on SPDs protection characteristics have been analyzed and discussed with the purpose of determination of requirements for proper surge protection and coordination of applied SPDs.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
