Abstract

For getting the coordinate of contactor on CCL, the measurement system transformed resistance into voltage by providing constant current on CCL. The system includes MCU, 3A constant current source, MOSFET switch circuit, signal amplifier circuit and A/D converter. By the curve-fitting method, the equipotent lines of CCL were simulated with MATLAB according to the discrete data. The equations of equipotent lines were obtained with second-order polynomial fitting method. The two curves which the contactor located in were acquired with local linearization method, and the coordinate was gained by calculating solving equation groups.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.