Cooling enhancement by nanofluid mixed convection inside a horizontal vented cavity submitted to sinusoidal heating

Abstract

PurposeThe purpose of this paper is to investigate numerically mixed convection of Al2O3-water nanofluids flowing through a horizontal ventilated cavity heated from below by a temperature varying sinusoidally along its lower wall. The simulations focus on the effects of different key parameters, such as Reynolds number (200 ≤ Re ≤ 5,000), nanoparticles’ concentration (0 ≤ ϕ ≤ 0.1) and phase shift of the heating temperature (0 ≤ γ ≤ π), on flow and thermal patterns and heat transfer performances.Design/methodology/approachThe Navier–Stokes equations describing the nanofluid flow were discretized using a finite difference technique. The vorticity and energy equations were solved by the alternating direction implicit method. Values of the stream function were obtained by using the point successive over-relaxation method.FindingsThe simulations were performed for two modes of imposed external flow (injection and suction). The main findings are that the dynamical and thermal fields are affected by the parameters Re, ϕ, γ and the applied ventilation mode; the addition of nanoparticles leads to an improvement of heat transfer rate and an increase of mean temperature inside the enclosure; the heat exchange performance and the better cooling are more pronounced in suction mode; the phase shift of the heating temperature may lead to periodic solutions for weaker values of Re and contributes to an increase or a decrease of heat transfer depending on the value of ϕ and the convection regime.Originality/valueTo the best of the authors’ knowledge, the problem of mixed convection of a nanofluid inside a vented cavity using the injection or suction technics and submitted to non-uniform heating conditions has not been treated so far.