Abstract
The majority of galvanometric on-off furnace controllers can be converted to proportional operation, with a consequent improvement of control characteristic, by injecting a low-frequency modulating signal into the thermocouple circuit. This note describes a simple battery-powered oscillator designed to be added to existing controllers; one lead from the thermocouple is broken and the free ends are connected to the output terminals of the oscillator. An extension to the basic modulator enables the circuit to compensate changes in the voltage of the mains supply to the furnace.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.