Abstract
For the solution of elliptic problems, fractional step methods and in particular alternating directions (ADI) methods are iterative methods where fractional steps are sequential. Therefore, they only accept parallelization at low level. In [T. Lu, P. Neittaanmäki, X.C. Tai, A parallel splitting-up method for partial differential equations and its applications to Navier–Stokes equations, RAIRO Modél. Math. Anal. Numér. 26 (6) (1992) 673–708], Lu et al. proposed a method where the fractional steps can be performed in parallel. We can thus speak of parallel fractional step (PFS) methods and, in particular, simultaneous directions (SDI) methods. In this paper, we perform a detailed analysis of the convergence and optimization of PFS and SDI methods, complementing what was done in [T. Lu, P. Neittaanmäki, X.C. Tai, A parallel splitting-up method for partial differential equations and its applications to Navier–Stokes equations, RAIRO Modél. Math. Anal. Numér. 26 (6) (1992) 673–708]. We describe the behavior of the method and we specify the good choice of the parameters. We also study the efficiency of the parallelization. Some 2D, 3D and high-dimensional tests confirm our results.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.