Convective heat transfer in fire spread through fine fuel beds

Abstract

An extensive set of wind-tunnel fires was burned to investigate convective heat transfer ahead of a steadily progressing fire front moving across a porous fuel bed. The effects of fuel and environmental variables on the gas temperature profile and the ‘surface wind speed’ (gas velocity at the fuel bed surface) are reported. In non-zero winds, the temperature of the air near the fuel bed surface decays exponentially with distance from the fire front. In zero winds, the temperature decreases rapidly within a very short distance of the flame front, then decays slowly thereafter. The maximum air temperature decreases as the free stream wind speed, packing ratio and fuel moisture content increase. The characteristic distance of the exponential decay increases strongly with the free stream wind speed and decreases with the packing ratio and surface area-to-volume ratio of the fuel. The surface wind speed depends strongly on the free stream wind speed, and to a lesser extent on packing ratio, fuel bed depth and fuel moisture content. There are three general regimes for the surface flow: (1) a constant velocity flow of approximately half the free stream flow, far from the flame front; (2) an intermediate zone of minimum flow characterised by low or reversed flow; and (3) a region near the flame front where the velocity rises rapidly almost to the free stream velocity. The boundaries between the three regions move further from the flame front with increasing wind speed, in a way which is only slightly affected by fuel geometry.