Abstract

A DfR (Design for Reliability) approach which is systematically based on simulation, sensitivity analysis and experimental validation is applied for identifying, understanding and controlling the key factors which determine the solder joint reliability of eWLB (Embedded Wafer Level Ball Grid Array) packages that carry embedded 77 GHz dies and sit on hybrid PCB (Printed Circuit Board) stacks. The hybrid stack investigated in this work is characteristic to automotive RADAR (Radio Detection And Ranging) applications and consists of one low-loss RF (Radio Frequency) layer and several FR4 layers. In line with previous work [1], the mechanical material properties of the low-loss RF laminate material are found to be the key factor. Simulation is used to systematically screen for mechanical properties which are favorable for achieving a high solder joint reliability on the unconstrained PCBs used for standardized solder joint reliability testing. A simplified virtual assessment of PCBs constrained by the mounting in system module housings is done. Both simulation and experimental results show that RF laminate materials with low Young’s modulus are the class of materials which allows for the highest solder joint reliability for all the conditions investigated in this study.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.