Abstract
Quantum dots (QDs) can be used for a wide range of practical applications including solar energy conversion, light-emitting display, bio-imaging, and sensing. However, toxic heavy metal elements of Pb- and Cd-based QDs cause potential environmental problems and limit their wide applicability. To overcome this limitation, CuInS2 (CIS) QDs, which have a bulk bandgap energy of 1.5eV and relatively high absorptivity, can be a good alternative. However the photoluminescence quantum yield (PLQY) of CIS QDs is too low for practical applications. Here we investigate the effects of experimental factors in the solution synthesis of CIS/ZnS QDs on intrinsic defects and surface defects from photoluminescence (PL) analysis. A heating-up method is used with dodecanethiol as a sulfur source, a ligand, and a medium. The Cu-to-In feeding ratio is changed to control the PL spectrum in the range of visible to near infrared (NIR) frequencies. The PLQY is increased above 40% in all of the ranges through ZnS shell passivation and additional process optimization (e.g., controlled cooling rate and additional feeding of In3+ ion precursor). This work demonstrates the role of intrinsic defects in PL and the importance of suppressing the formation of the surface defects to increase the PLQY.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
