Abstract
AbstractA vacuum infusion process was implemented to produce composite specimens from a random glass filament mat and an acrylic modified polyester resin curable upon irradiation with ultraviolet (UV) light. Through localized irradiation with UV light during the reinforcement impregnation, the viscosity of the flowing resin was increased selectively. This allowed converging–diverging flow patterns with defined inclusions to be realized and racetracking along reinforcement edges to be suppressed. The approach is based on radical photopolymerisation. Here, the degree of cure and the viscosity of the resin increase under direct irradiation, such that the resin gels and the flow stalls in a matter of seconds, but remain unchanged in areas covered with an opaque mask. While this study is concerned with the feasibility of the process, potential practical applications are in flow control for Liquid Composite Moulding, that is, compensation for local variations in the fiber volume fraction and permeability of reinforcements.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
