Abstract

This paper focuses on the design of pneumatic conveying control system, including the design of both hardware and software part. The hardware part is mainly about building a test bed. Under certain wind conditions, by controlling the rotary feed valve to achieve the control of sand/dust concentration. The software part is to make use of LabVIEW to develop a screen display program, which can achieve real-time data acquisition and control. The paper consists of three parts, the pneumatic control system hardware design, the pneumatic conveying control system software design and then we use Origin to linear fit the wind speed parameters collected back.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.